Four advantages of ZJN sludge drying equipment

The drying process of ZJN sludge drying equipment is determined by the different characteristics of sludge. In the whole drying process, the size and temperature of hot air will be adjusted with the fluctuation of sludge moisture content to ensure that the sludge is in a dry environment at all times. Therefore, the sludge drying equipment has many advantages and features. The editor will explain it in four aspects.

1、 Strong production capacity and low production cost. ZJN sludge drying equipment is a large mechanical equipment. The equipment adopts three sleeve structure, with large internal storage space. In the drying process, the "three-stage positive and negative lifting, guiding material" and "W + s" feeding process can make the sludge move back and forward repeatedly in the equipment, so that the sludge can fully contact with the hot air, at the same time, it can improve the utilization rate of heat energy and accelerate the drying rate of sludge.

2、 A wide range of heat sources. The heat sources that can be used as sludge drying equipment include coal, oil, gas, biomass fuel, industrial waste heat, steam, etc. The matching heat source equipment produced by the company can realize the combination of heat sources, such as gas, oil, coal, gas and other forms. Users can choose suitable heat source according to their own conditions.

3、 Automatic operation, simple and convenient. The whole set of equipment adopts the integrated mode in drying operation. Generally, only two or three operators are needed to complete the whole drying operation, which is simple and convenient.

4、 Safe, no pollution. The whole set of equipment lines are managed in a unified way. In normal operation, the circuit can be switched on or off by means of manual or automatic switch. In case of fault or abnormal operation, cut off the circuit or give an alarm with the help of the protection appliance. The equipment operates under negative pressure, sealed tightly, and there is no gas leakage in the drying process, so as to ensure the clean and tidy production environment. At the same time, the waste gas after production can only be discharged after special treatment and reaching the national emission standard.