What are the operation points to improve the performance of chemical sludge dryer

Chemical sludge dryer is widely praised in the drying market for its advantages of small floor area, stable equipment performance, strong production capacity and high drying efficiency. Different from the traditional single drum dryer, the three-stage multi loop chemical sludge dryer makes full use of heat and improves heat and mass transfer efficiency through the mode of "layer by layer drying" and "deep dehydration" Structure, reduce the heat consumption of the equipment, more energy-saving and environmental protection. After the introduction of the equipment, some enterprises have some doubts about how to operate to speed up the production efficiency and improve the performance of the equipment. Therefore, I will discuss with you what are the operation points to further improve the performance of the chemical sludge dryer.

1. Uniform feeding

In order to make the chemical sludge dryer play a better production capacity, ensuring uniform feeding is the basic condition. If the feeding is too little, the equipment will run at low load, resulting in the decline of production capacity. Therefore, before drying, it is necessary to reasonably configure the feeding amount, ensure continuous feeding, and make the equipment operate under normal load conditions, so as to better complete the drying operation. In addition, if the particle size of the material can be controlled to make it uniform in a certain range, it is also more effective to improve the performance of the dryer and reduce the difficulty of drying operation.

2. Control the moisture in a certain range

Materials with too high humidity need to evaporate more moisture when drying, which will increase the drying time of materials in the chemical sludge dryer cylinder, and need to consume more heat, which leads to the rise of production costs of enterprises. Therefore, in order to avoid the economic loss of users, it is necessary to control the moisture content of sludge before entering the equipment. The smaller the water content is, the shorter the drying time is, the greater the output will be.

3. Raise the temperature properly

Within the specified range, properly increasing the temperature in the cylinder can help to ensure sufficient heat, which is an important condition for increasing production of chemical sludge dryer.

After paying attention to the above details and making improvements from these angles, the thermal efficiency of the chemical sludge dryer will be greatly improved, and the drying operation production will be accelerated, so as to improve the economic benefits and resource utilization rate of the enterprise.