How to configure the production line of municipal sludge drying equipment

The production line of municipal sludge drying equipment is mainly used for upgrading and dewatering of municipal sludge, domestic sludge, pipe network sludge, sewage sludge and other high humidity and high viscosity sludge. Due to the high water content and high viscosity of municipal sludge, it is difficult to treat it. After dewatering by municipal sludge drying equipment, the moisture content is reduced to the required standard, and the effect of volume reduction and reduction is very obvious. It not only solves the environmental pollution problem caused by no place accumulation of municipal sludge, but also can be used in building materials, land use, fuel utilization and other aspects after drying, which is widely used.

Municipal sludge drying equipment production line includes what

In fact, the configuration of sludge drying production line needs to be selected and configured according to the actual needs of users. Generally, the following process flow is required in the process of municipal sludge drying: heating, feeding, dispersing, drying, discharging, waste gas treatment, etc. Therefore, the complete municipal sludge dryer production line needs to include heating equipment, feeding and discharging device, drying host, induced draft fan, dust removal equipment, PLC control system and so on. How to choose the specific processing process steps, should be integrated with the actual conditions of planning and design. For example, the heating equipment is selected according to the fuel used, the feeding device is selected according to the characteristics and particle size of the material, the specification, model and size of the dryer are configured according to the output and moisture content requirements, and the dust removal scheme is configured according to the waste gas disposal requirements, etc. Therefore, the municipal sludge drying equipment production line scheme is different for different user needs.

Configuration skills of municipal sludge drying equipment production line

1. The configuration of production line should be selected according to the actual drying demand. If the configuration is too small or too large, it will not meet the daily production needs of users, and the equipment will run overload, which not only has a high failure rate, but also affects the service life of the equipment. Once the equipment breaks down and the production line stops production, the economic loss of the enterprise will be greater. If the configuration is too high, it will cause waste of resources, not only the cost of purchasing equipment will increase, but also the cost of equipment operation will be more.

2. Different material characteristics, working environment, different discharge requirements, these factors will affect the specifications and design of the whole production line, which are closely linked. If there is any problem in the intermediate step, it will also affect the follow-up work. Therefore, if users are not familiar with these, they can also find professional manufacturers of municipal sludge drying equipment to design and plan.