How to avoid desoldering of chemical sludge drying equipment

In the process of producing chemical sludge drying equipment, the manufacturer cannot do without welding. Do not underestimate welding, although the gap is small, but it hides a lot of knowledge. In the chemical sludge drying equipment welding, do not easily let go of small problems, to solve small problems, is to avoid causing more serious problems.

The structure of chemical sludge drying equipment is composed of three cylinders with different diameters. And which cylinder is welded with steel. In the process of long-term use, the phenomenon of weld desoldering is easy to occur. If the gap of desoldering is small, it's OK, and it won't cause too much impact, but it may become larger and larger as time goes on, and equipment failure will occur. Therefore, the gap of desoldering can not be ignored. In the drying process of chemical sludge drying equipment, operators need to maintain the equipment regularly, so as to better ensure the safety of the equipment production and prolong the service life of the equipment. However, some experienced sludge drying equipment manufacturers have many ways to solve the problem of desoldering.

First of all, some small diameter weld bead and small current welding can adopt the standard layered welding method. The purpose of this is to reduce the thermal stress and avoid serious deformation or cracks.

Secondly, when welding, the grounding point of the welding machine should be on the cylinder of the drying equipment, not on the bearing, so as to avoid the spark generated by the current passing through the bearing, causing damage to the cylinder surface of the drying equipment and the bearing raceway.

Thirdly, before welding chemical sludge drying equipment, safety welding measures should be taken.

Fourth, the chemical sludge drying equipment can also be removed for repair, that is, the roller coupling parts above the mechanical equipment are removed and installed in the drying equipment after repair.

Fifthly, in the welding process, operators need to use the ruler template to check the welding parts to ensure that the overall dimensions are qualified.