Precautions for using electroplating sludge dryer

First of all, before the start-up of the electroplating sludge dryer, it is necessary to do a good job in the inspection of the equipment to ensure whether the connection of various parts of the equipment is normal, whether the screws and nuts are loose, and whether the lubricating oil between the parts is sufficient; it is necessary to clean the dust and flying catkins on the equipment, so as not to affect the normal operation and production of the equipment.

Secondly, in the process of production and operation of electroplating sludge dryer, the operators need to check the feeding and discharging of the equipment from time to time. If the material is blocked, the equipment needs to be dredged in time to avoid affecting the operation and production of the equipment; Operators also need to check the operation of various parts of the equipment from time to time. Once the abnormal sound of the equipment is found, they need to stop the machine immediately to check and eliminate the equipment fault, and then carry out the production operation; If it is found that the wear of equipment parts is serious, it can not be delayed to the limit of the use of equipment parts. In this way, it will cause more serious damage to the equipment. It is necessary to stop the machine immediately for inspection and replace the parts. In this way, the frequency of equipment failure can be greatly reduced and the service time of the equipment can be prolonged.

In the process of using electroplating sludge, operators need to strictly follow the operation process formulated by the manufacturer and implement it seriously, which can greatly reduce the equipment failure and ensure the smooth operation of equipment production.

Third, when the electroplating sludge dryer is shut down, it is necessary to stop the feeding of the equipment first, wait until the dryer has dried all the materials inside the cylinder and sent them out of the cylinder, then stop the heat supply of the equipment, and then shut down the dryer after the heat of the cylinder is slowly reduced. The purpose of this is not only to finish the drying of the materials inside the cylinder, but also to avoid the drying of the materials inside the cylinder due to local high temperature It causes the deformation of the cylinder and prolongs the service life of the equipment.

Fourth, after the electroplating sludge is shut down, it is necessary to clean the equipment barrel. The purpose of this is to ensure the next operation of the equipment, reduce the corrosion of the equipment barrel and prolong the service life of the equipment.

In addition, we need to do a good job in daily equipment maintenance, which can ensure the effect of equipment use, reduce the frequency of equipment failure, and extend the service life of the equipment.